The products of Cnc machining
From:http://www.goldspace.cc/ Time:2010-8-23
The products of Cnc machining
As the controller hardware evolved, the mills themselves also evolved. One change has been to enclose the entire mechanism in a large box as a safety measure, often with additional safety interlocks to ensure the operator is far enough from the working piece for safe operation. Most new Cnc machining built today are completely electronically controlled.
Many of the commands for the experimental parts were programmed "by hand" to produce the punch tapes that were used as input.
While the system was being experimented with, John Runyon made a number of subroutines on the famous Whirlwind to produce these tapes under computer control. Users could input a list of points and speeds, and the program would generate the punch tape. In one instance, this process reduced the time required to produce the instruction list and mill the part from 8 hours to 15 minutes. This led to a proposal to the Air Force to produce a generalized "programming" language for numerical control, which was accepted in June 1956.
Starting in September Ross and Pople outlined a language for machine control that was based on points and lines, developing this over several years into the APT programming language. In 1957 the Aircraft Industries Association (AIA) and Air Material Command at the Wright-Patterson Air Force Base joined with MIT to standardize this work and produce a fully computer-controlled NC system. On 25 February 1959 the combined team held a press conference showing the results, including a 3D machined aluminum ash tray that was handed out in the press kit.
Meanwhile, Patrick Hanratty was making similar developments at GE as part of their partnership with G&L on the Numericord. His language, PRONTO, beat APT into commercial use when it was "released" in 1958.Hanratty then went on to develop MICR magnetic ink characters that were used in cheque processing, before moving to General Motors to work on the groundbreaking DAC-1 CAD system.
TAG: Cnc machining Aluminum heat sink Communication housings Heat sinks Aluminum panels Die Castings Precision machining parts LED Lights frame Sheet Aluminum computer chassis Precision stamping parts
Print | Back
|
Experienced R&D Department